• | The backup application cannot connect to the Exchange server. To verify this, you can attempt a restore operation to an ordinary database on the same server (a database that is not configured in the recovery storage group). Before performing this test, you must either delete the recovery storage group so that the server exhibits ordinary restore behavior or configure the Recovery SG Override registry key. If the error reoccurs, the problem is likely server-wide and not specific to the recovery storage group. If a "Database Not Found" error appears in the Application Event Log, the problem is not with connecting to the server but with connecting to the recovery storage group. Important Be certain that the database you are specifying for this test is mounted, or that it is a test database that can be destroyed. If you have set the Recovery SG Override registry value to 1 and the database specified is not mounted, it will be overwritten immediately in the restore attempt. If the database is mounted, a "Database in use" error will be logged, restore will fail, and the existing database will be unaffected. |