Iron(III) oxide
From Wikipedia, the free encyclopedia
Iron(III) oxide | |
---|---|
Other names | Ferric oxide Hematite |
Identifiers | |
CAS number | |
Properties | |
Molecular formula | Fe2O3 |
Molar mass | 159.69 g/mol |
Appearance | red-brown solid |
Density | 5.24 g/cm3, solid |
Melting point |
1565 °C (1838 K) decomp. |
Solubility in water | insoluble |
Structure | |
Crystal structure | rhombohedral |
Thermochemistry | |
Std enthalpy of formation ΔfH |
−825.50 kJ/mol |
Hazards | |
EU classification | not listed |
Flash point | non-flammable |
Related Compounds | |
Other anions | Iron(II) sulfide |
Other cations | Iron(II) oxide Iron(II,III) oxide Ruthenium(IV) oxide Osmium(IV) oxide |
Except where noted otherwise, data are given for materials in their standard state (at 25 °C, 100 kPa) Infobox disclaimer and references |
Iron(III) oxide — also known as ferric oxide, Hematite, red iron oxide, synthetic maghemite, colcothar, or simply rust — is one of the several oxide compounds of iron, and has paramagnetic properties. Its chemical formula is Fe2O3.
Contents |
[edit] Different forms
- Alpha phase - rhomboedric, the most common form. Occurs naturally as the mineral hematite. Is mined as the main ore of iron. It is antiferromagnetic at low temperatures, otherwise it is ferromagnetic. It is easy to prepare using both thermal decomposition and precipitation in the liquid phase. Its magnetic properties are dependent on many factors, e.g. pressure, particle size, and magnetic field intensity.
- Beta phase - cubic face centered, metastable, at temperatures above 500 °C converts to alpha phase. It can be prepared by e.g. reduction of hematitte by carbon, pyrolysis of iron(III) chloride solution, or thermal decomposition of iron(III) sulfate.
- Gamma phase - cubic, metastable, converts to the alpha phase at high temperatures. Occurs naturally as the mineral maghemite. Ferrimagnetic. Ultrafine particles smaller than 10 nanometers are superparamagnetic. Can be prepared by thermal dehydratation of gamma iron(III) oxide-hydroxide, careful oxidation of iron(II,III) oxide. The ultrafine particles can be prepared by thermal decomposition of iron(III) oxalate.
- Epsilon phase - rhombic, shows properties intermediate between alpha and gamma. So far has not been prepared in pure form; it is always mixed with the alpha phase or gamma phases. Material with a high proportion of epsilon phase can be prepared by thermal transformation of the gamma phase. The epsilon phase is metastable, transforming to the alpha phase at between 500-750 °C. Can also be prepared by oxidation of iron in an electric arc or by sol-gel precipitation from iron(III) nitrate.
- Other phases - high pressure, amorphous [1]
[edit] Uses
Iron(III) oxide is often used in magnetic storage, for example in the magnetic layer of floppy disks. These consist of a thin sheet of PET film, coated with iron(III) oxide. The particles can be magnetised to represent binary data. MICR (Magnetic Ink Character Recognition) also uses iron(III) oxide compounds, suspended in an ink which can be read by special scanning hardware.
A very fine powder of ferric oxide is known as jeweller's rouge, red rouge, or simply rouge. It is used to put the final polish on metallic jewellery and lenses, and historically as a cosmetic.
Rouge cuts slower than some modern polishes, such as cerium(IV) oxide, but is still used in optics fabrication and by jewelers for the superior finish it can produce. When polishing gold, the rouge slightly stains the gold, which contributes to the appearance of the finished piece. Rouge is sold as a powder, paste, laced on polishing cloths, or solid bar (with a wax or grease binder). Other polishing compounds are also often called "rouge", even when they do not contain iron oxide. Jewelers remove the residual rouge on jewelry by use of ultrasonic cleaning.
Iron(III) oxide is used in the production of pure iron in a blast furnace. Iron(III) oxide is also used in an extremely exothermic reaction called a thermite reaction.[1]
Iron(III) oxide is also used as a pigment, under names Pigment Black 11, Pigment Brown 6, Pigment Brown 7, and Pigment Red 101 (also Iron Oxide Red). Some of them, eg. Pigment Red 101 and Pigment Brown 6, are Food and Drug Administration (FDA)-approved for use in cosmetics.
Nanoparticles of iron(III) oxide are biocompatible, non-toxic, are chemically active on their surface, and are magnetic. They find wide use in biomedical applications. Can be used as contrast agents in magnetic resonance imaging, in labeling of cancerous tissues, magnetically controlled transport of pharmaceuticals, localized thermotherapy (where the tissue is labeled by iron oxide nanoparticles, then heated by application of AC field to particles), and preparation of ferrofluids. [2]
[edit] See also
- Iron oxides
- Iron(II) oxide
- Magnetite (Iron(II,III) oxide)
- Red ochre
- Rust
[edit] General references
N. N. Greenwood, A. Earnshaw, Chemistry of the Elements, Pergamon Press, 1984.
[edit] References
- ^ Adlam & Price, Higher School Certificate Inorganic Chemistry, Leslie Slater Price, 1945.