Block Tatting, continuous round Snowflake. Made with size #20 thread. If you need help with learning the Block Tatting: Click Here By Roger aka Freedman NOTE: If your using a larger thread, like #10 make your inside blocks with only four chains of 6 each. Approx. 3" - 7.62 Cm Center: Make block of 6ds for each chain of 6 to make block. (make sure you leave a clip at the end of loop of first chain, to make mock Picot) (If using #10 thread make blocks 6ds but only 4 chains to make the block) On the 6th chain of the block reverse, make chain of 6ds p 6ds Do Not Reverse Vsp, Start next block, bend down and join on the p of last chain of first block. Continue around for 6 blocks. On the last chain of 6 p 6 join to base of first block made. Do Not Cut. RW ** Make a chain of 6ds p 6ds DNR Make a chain of 6 to start the block and bend it down and join on P of the chain of previous round. Reverse and make this block only 5 chains. On the 5th chain, make another chain of 6ds P 6ds bend it down and join it to the base on opposite side. Chain over to the next side with chain of 6ds join it the base and continue around as above.** (if using #10 thread only do 4 ds over) |