Space Shuttle Enterprise
From Wikipedia, the free encyclopedia
 Enterprise at SLC-6 at Vandenberg AFB |
|
| OV designation | OV-101 |
|---|---|
| Country | United States |
| Contract award | July 26, 1972 |
| Named after | USS Enterprise, NCC-1701 (fictional) |
| Status | On display at Smithsonian Institution, Steven F. Udvar-Hazy Center[1] |
| First flight | Taxi Test February 15, 1977 |
| Last flight | Free Flight October 26, 1977 |
| Time spent in space | Never flew in space |
| Number of orbits | 0 |
The Space Shuttle Enterprise (NASA Orbiter Vehicle Designation: OV-101) was the first Space Shuttle built for NASA. It was constructed without engines or a functional heat shield, and was therefore not capable of space operations; its purpose was to perform test flights in the atmosphere.[2]
Originally, Enterprise had been intended to be refitted for orbital flight, which would have made it the second space shuttle to fly after Columbia.[2] However, during the construction of Columbia, details of the final design changed, particularly with regard to the weight of the fuselage and wings. Refitting Enterprise for flight would have involved dismantling the orbiter and returning the sections to subcontractors across the country. As this was an expensive proposition, it was determined to be less costly to build Challenger around a body frame (STA-099) that had been created as a test article.[2] Similarly, Enterprise was considered for refit to replace Challenger after the latter was destroyed, but Endeavour was built from structural spares instead.[2][3]
Contents |
[edit] Service
Construction began on the first orbiter on June 4, 1974.[2] Designated OV-101, it was originally planned to be named Constitution. However, a write-in campaign caused it to be renamed after the Starship Enterprise, featured on the television show Star Trek.[3]
The design of OV-101 was not the same as that planned for OV-102, the first flight model; the tail was constructed differently, and it did not have the interfaces to mount OMS pods. A large number of subsystems - ranging from main engines to radar equipment - were not installed on this vehicle, but the capacity to add them in the future was retained. Instead of a Thermal Protection System, its surface was primarily fiberglass.
During summer 1976, the orbiter was used for ground vibration tests, allowing engineers to compare data from an actual flight vehicle with theoretical models.[2]
On September 17, 1976, Enterprise was rolled out of Rockwell's plant at Palmdale, California. In recognition of its fictional namesake, Star Trek creator Gene Roddenberry and most of the cast of the original series of Star Trek were on hand at the dedication ceremony.
[edit] Approach and landing tests (ALT)
On January 31, 1977, it was taken by road to Dryden Flight Research Center at Edwards Air Force Base, to begin operational testing.[2][4]
While at NASA Dryden, Enterprise was used by NASA for a variety of ground and flight tests intended to validate aspects of the shuttle program.[5] The initial nine-month testing period was referred to by the acronym ALT, for "Approach and Landing Test".[2][6]These tests included a maiden "flight" on February 18, 1977 atop a Boeing 747 Shuttle Carrier Aircraft (SCA) to measure structural loads and ground handling and braking characteristics of the mated system. Ground tests of all orbiter subsystems were carried out to verify functionality prior to atmospheric flight.
The mated Enterprise/SCA combination was then subjected to five test flights with Enterprise unmanned and unactivated. The purpose of these test flights was to measure the flight characteristics of the mated combination. These tests were followed with three test flights with Enterprise manned in order to test the shuttle flight control systems.[2]
Finally, Enterprise underwent five free flights where the craft separated from the SCA and was landed under astronaut control. These tests verified the flight characteristics of the orbiter design and were carried out under several aerodynamic and weight configurations.[6]
[edit] Preparation for STS-1
Following the ALT program, Enterprise was ferried between several NASA facilities to configure the craft for vibration testing. In June 1979, it was mated with an external tank and solid rocket boosters (known as a boilerplate configuration) and tested in a launch configuration at Kennedy Space Center Launch Pad 39A.[3] In 1984, it was used to test the Air Force shuttle facilities at Vandenberg Air Force Base, including a full mating on the SLC-6 launch pad.[3]
[edit] Retirement
With the completion of critical testing, Enterprise was partially disassembled to allow certain components to be reused in other shuttles, then underwent an international tour visiting France, Germany, Italy, the United Kingdom, Canada, and the U.S. states of California, Alabama, and Louisiana (during World Expo 84). It was also used to fit-check the never-used shuttle launch pad, SLC-6 at Vandenberg AFB, California. Finally, on November 18, 1985, Enterprise was ferried to Washington, D.C., where it became property of the Smithsonian Institution.[3]
[edit] Post-Challenger
After the Challenger disaster, NASA had a choice of which shuttle to use as a replacement. Refitting Enterprise with all of the necessary equipment needed for it to be used in space was considered, but instead it was decided to use spares from the fabrication of Discovery and Atlantis to build Endeavour.[3]
[edit] Post-Columbia
In 2003, after the breakup of Columbia during re-entry, the Columbia Accident Investigation Board removed a fiberglass panel from Enterprise's wing to perform analysis of the material.[8] The test involved firing a piece of foam at high velocity at the panel. While the panel was not broken as a result of the test, the impact was enough to permanently deform a seal. As the Reinforced Carbon-Carbon (RCC) panel on Columbia was 2.5 times weaker, this suggested that the RCC leading edge would have been shattered. Additional tests on the fiberglass were canceled in order not to risk damaging the test apparatus, and a panel from Discovery was tested to know the effects of the foam on a similarly-aged RCC leading edge.
On July 7, 2003 a second foam impact test was performed by Southwest Research Institute, which used a foam block of similar size, mass and speed to that which struck Columbia. It created a hole 41 cm by 42.5 cm (16.1 inches by 16.7 inches) in the protective RCC panel. The tests clearly demonstrated that a foam impact of the type Columbia sustained could seriously breach the protective RCC panels on the wing leading edge.
The Columbia Accident Investigation Board determined that this impact caused a breach of a Reinforced Carbon-Carbon panel along the leading edge of Columbia's left wing, allowing super-heated gases generated during re-entry to enter the wing and cause structural collapse. This caused Columbia to spin out of control, breaking up with the loss of all crew.
[edit] Current status
Enterprise was stored at the Smithsonian's hangar at Washington Dulles International Airport before it was restored and moved to the newly-built Smithsonian's National Air and Space Museum's Steven F. Udvar-Hazy Center at Dulles, where it is the centerpiece of the space collection.[1]
[edit] Gallery
 Space Shuttle Enterprise and the Shuttle Carrier Aircraft (SCA) at CFB Goose Bay, Labrador in 1983. |
 Space Shuttle Enterprise at Ellington Field in March of 1978. |
 Enterprise at Ellington Field in March 1978. |
 Enterprise at Ellington Field in March 1978. |
 Enterprise at Ellington Field in March 1978. |
 Enterprise at Ellington Field in March 1978. |
 Enterprise at the Steven F. Udvar-Hazy Center |
 Enterprise ALT Program Logo. |
 Space Shuttle Enterprise 747 takeoff (Theora) |
 Space Shuttle Enterprise 747 separation (Theora) |
 Space Shuttle Enterprise landing (Theora) |
[edit] See also
- List of human spaceflights
- List of Space Shuttle crews
- List of space shuttle missions
- Timeline of Space Shuttle missions
- List of human spaceflights chronologically
[edit] References
- ^ a b NASA (2000). "Shuttle Enterprise at Center of Museum's Space Hangar". NASA. Retrieved on November 28, 2007.
- ^ a b c d e f g h i Jenkins, Dennis R. (2007). Space Shuttle: The History of the National Space Transportation System. Voyageur Press, 524 pages. ISBN 0963397451.
- ^ a b c d e f NASA (2000). "Enterprise (OV-101)". National Aeronautics and Space Administration. Retrieved on November 28, 2007.
- ^ NASA (2005). "Space Shuttle Basics". NASA. Retrieved on November 28, 2007.
- ^ NASA (2002). "Space Shuttle Approach and Landing Tests (ALT)". NASA. Retrieved on November 28, 2007.
- ^ a b NASA - Dryden Flight Research Center (1977). "Shuttle Enterprise Free Flight". NASA. Retrieved on November 28, 2007.
- ^ NASA (1979). "Shuttle Orbiter Enterprise on Launch Complex 39". NASA. Retrieved on January 21, 2008.
- ^ Harwood, William (June 4, 2003). "Critical foam impact test planned for Thursday", Spaceflight Now. Retrieved on 2007-07-12.
[edit] External links
- Aerial view of Enterprise in 1978, as it is hoisted into Marshall's Dynamic Test Stand for the Mated Vertical Ground Vibration test.
- Enterprise being worked on in the weight & balance hangar at Dryden Flight Research Center.
| Spacecraft named Enterprise |
|---|
| NASA Space Shuttle (1976–1985) • Virgin Space Ship (2008—) • Star Trek starships (Fictional) |
|
||||||||||||||||||||||||||||
|
||||||||||||
